Skip to content
Discuss your project
Home

Software

Embedded software and firmware development

We develop the low-level software of your device: firmware, drivers, interfaces and data logic, matched to the electronics it runs on.

Concept illustration: assembled circuit board with microcontroller and circular connector between housing top and housing base
AI-generated concept illustration, not a customer project.

When we support you

  • A new device needs firmware, and the hardware is only just being created.
  • Existing firmware is to be continued or extended.
  • Hardware, software and mechanics have so far been considered separately, and interface problems show up late.
  • Your team lacks capacity or specialist knowledge for low-level software.

What we take on for your software

  1. Firmware

    We develop the software that runs directly on the electronics of your device and implements the functions in the device.

  2. Drivers

    We connect the components and assemblies of your hardware by means of drivers so that the firmware can control them.

  3. Interfaces

    We define the interfaces between firmware, hardware and the operation on the device or via an app before development.

  4. Data logic

    We develop the logic with which your device processes and provides data.

  5. Coordination with the hardware

    We develop firmware and electronics in parallel and continuously align the two.

  6. Further development of existing firmware

    We continue firmware that was started elsewhere. We review existing documents first and tell you what is missing.

Where the software is created in the process

  1. 02

    Develop the system architecture

    The software is aligned early with hardware and mechanics.

  2. 03

    Implement development

    We develop the firmware and regularly align progress with you.

  3. 04

    Validate the prototype

    The firmware runs on the assembled prototype and is tested.

  4. 05

    Prepare industrialisation

    Test concept and handover to series production are secured.

You can find all five steps on the home page.

Questions about embedded software

Can you take on just the firmware?

Yes. You can hand over individual tasks such as the firmware, or commission a joint development project up to preparation for series production. If needed, it then continues within the kessler Group.

Can you continue existing firmware?

Yes. We continue firmware and further develop devices that were started elsewhere. We review existing documents first and tell you what is missing.

How does a project start?

Briefly describe your project in the project form. You can add documents if you like. In the first call we discuss your development status, your goals and the next steps.

Discuss your project with us.

Briefly describe your project in the project form. You can add documents if you like. We will get back to you personally.

Discuss your project

Reach us directly

More services